User`s manual

Image Acquisition Control
86 Basler aviator Camera Link
For more information about determining the maximum allowed frame rate with the current camera
settings, see Section 5.7 on page 90.
For more information about frame buffering, see Section 3 on page 37.
For more information about the 1X2-1Y and 1X-2YE tap geometries, see Section 6.2 on page 95.
As shown in the timing charts, the exposure of a new image can start while the
camera is reading a previously acquired image out of the sensor. However, the
exposure time for the new image must not end while the readout of the
previous image is still in progress. The best way to avoid this problem is to
determine the maximum allowed frame rate with the camera’s current settings and
to simply make sure that you do not attempt to capture images at a rate that is
higher than the allowed maximum.