User`s manual

Physical Interface
Basler aviator Camera Link 27
2.8.2 Characteristics
The camera is equipped with two physical input lines designated as input line 1 and input line 2.
The input lines are accessed via the 12-pin receptacle on the back of the camera.
As shown in the I/O line schematic, each input line is opto-isolated. See the previous section for
input voltages and their significances. The absolute maximum input voltage is +30.0 VDC. The
current draw for each input line is between 5 and 15 mA.
Figure 10 shows an example of a typical circuit you can use to input a signal into the camera.
Fig. 10: Typical Input Circuit
For more information about input line pin assignments and pin numbering, see Section 2.2 on
page 16.
For more information about using the input lines, see Section 2.8.3 on page 28.