User`s manual

Physical Interface
20 Basler aviator Camera Link
2.4 Cabling Requirements
2.4.1 Power Cable
The end of the power cable that connects to the camera’s 6-pin connector must be terminated with
a Hirose micro plug (part number HR10A-7P-6S) or the equivalent. The cable must be wired as
shown in Figure 7.
For proper EMI protection, the power cable terminated with the Hirose connector and attached to
the camera must be a twin-cored, shielded cable. Also, the Hirose plug must be connected to the
cable shield and the shield must be connected to earth ground at the power supply.
Close proximity to strong magnetic fields should be avoided.
A power supply and cable assembly that meets these requirements is available from Basler.
Contact your Basler sales representative for more information.
Fig. 7: Power Cable
NOTICE
An incorrect plug can damage the 6-pin connector.
The plug on the cable that you attach to the camera’s 6-pin connector must have 6 female pins.
Use of a smaller plug, such as one with 4 pins, can damage the pins in the camera’s 6-pin
connector.
Hirose
HR10A-7P-6S
6-pin Plug
+12 VDC
+12 VDC
Not Connected
Not Connected
DC Gnd
DC Gnd
AC In
Shield
DC
Power
Supply
Power Cable