User`s manual

Features
116 Basler aviator Camera Link
7.8 Auto Functions
Auto functions control image properties and are the "automatic" counterparts of certain features,
such as the gain feature or the white balance feature, which normally require "manually" setting the
related parameter values. Auto functions are particularly useful when an image property must be
adjusted quickly to achieve a specific target value and when a specific target value must be kept
constant in a series of images.
An Auto Function Area of Interest (Auto Function AOI) lets you designate a specific part of the
image as the base for adjusting an image property. Each auto function uses the pixel data from an
Auto Function AOI for automatically adjusting a parameter value and, accordingly, for controlling
the related image property. Some auto functions use their own individual Auto Function AOI and
some auto functions share a single Auto Function AOI.
An auto function automatically adjusts a parameter value until the related image property reaches
a target value. Note that the manual setting of the parameter value is not preserved. For example,
when the Gain Auto function adjusts the gain parameter value, the manually set gain parameter
value is not preserved.
For some auto functions, the target value is fixed. For other auto functions, the target value can be
set, as can the limits between which the related parameter value will be automatically adjusted. For
example, the gain auto function lets you set an average gray value for the image as a target value
and also set a lower and an upper limit for the gain parameter value.
Generally, the different auto functions can operate at the same time. For exceptions, see the
following sections describing the individual auto functions.
Note that on cameras delivered from the factory, the exposure auto, gain auto, and
white balance auto (on color cameras) functions will all become enabled
whenever you power on or reset the camera. This behavior happens due to the
way that the camera’s configuration sets are set in the factory. More specifically, it
happens because the auto functions factory setup is selected as the default
configuration set and the default configuration set is designated as the "startup"
set. To change this behavior, you must change the configuration set settings. For
more information about configuration sets, see Section 7.19 on page 170.
A target value for an image property can only be reached if it is in accord with all
pertinent camera settings and with the general circumstances used for capturing
images. Otherwise, the target value will only be approached.
For example, with a short exposure time, insufficient illumination, and a low setting
for the upper limit of the gain parameter value, the Gain Auto function may not be
able to achieve the current target average gray value setting for the image.
You can use an auto function when binning is enabled (monochrome cameras
only). An auto function uses the binned pixel data and controls the image property
of the binned image.