User`s manual

Revision History
BASLER A202
k i
DRAFT
Revision History
Doc. ID Number Date Changes
DA 044001 3 July 2001 Initial release covering prototype cameras only.
DA 044002 26 October 2001 Initial release covering series production cameras.
DA044003 04 March 2002 Update to camera version 1.01:
Changed the minimum high time for the ExSync signal from 1 µs
to 4 µs. (Sect. 2.4.1, for example)
Changed the exposure time offset to 94.5 µs. (Sect. 3.2)
Changed the minimum setting for Timer 1 from 10 µs to 6 µs.
(Sections 3.2.1.3, 3.2.2.1, 4.2.4.3, 6.2.1)
Changed the decimal setting for 0 dB from 237 to 288.
(Sections 3.5.1, 3.5.2.1, 4.2.4.10, 4.2.4.12)
Changed the corresponding equations. (Sections 3.5.1 and 3.5.2)
Simplified the No Image troubleshooting chart (Section 6.2.1).
Added more frame grabber configuration file formats to Sect. 6.2.3.
DA044004
08-November-2002 Update to camera version 1.02:
Changed the low time between the last two lines from 25 ns to 7.9 µs
in the timing diagrams on pages 2-11 and 2-12.
Described the Camera Temperature feature (page 3-36).
Updated from the Classic Camera Configuration Tool to the Camera
Configuration Tool Plus (page 4-2).
Corrected the possible range of Timer 2 settings on page 4-13.
Added the Mirror Image binary command on page 4-20.
Revised the troubleshooting diagram on page 6-2.
DA044005
12 May 2003 Update to FPGA firmware version 1.05:
Updated Figures 2-4 and 2-5.
Updated the timing numbers on pages 3-5 through 3-9 and on
page 3-11.
Updated the frame rate formulas on page 3-27 and 3-31.
Updated the Timer 1 range on page 4-13.
Updated the timing numbers shown in the “No Image” trouble-
shooting guide in Section 6.
DA044006
22 July 2004 Update to include A102kc color cameras:
Updated Table 1-1 and added Figure 1-2.
Added Section 3.10 to describe color creation.
Added Section 5.5 to describe maximum thread length.
Updated troubleshooting table in Section 6.2.2 to include color
cameras.
DA044007
9 March 2005 Updated the gain range stated in Sections 3.5.1, 3.5.2.1, 4.2.4.10
and 4.2.4.12.
Updated the digital shift descriptions in Section 3.6.
Updated the available digital shift settings stated in Section 4.2.4.5.