User`s manual

Configuring the Camera
BASLER A102f 4-11
DRAFT
* When you lower the bytes per packet setting, the number of bytes needed to transmit a frame
(the packets per frame) will increase. Due to limitations in the DCAM structure, a maximum of
4095 packets per frame is allowed. If you set the bytes per packet too low, the number of
packets per frame will exceed the 4095 packet limit and the camera will not transmit frames
properly.
** The Data_Depth register, Color_Filter_ID register, Raw 8 Color_Coding_ID, and Raw 16
Color_Coding_ID are defined in version 1.31 of the IIDC specification.
Offset Name Notes
044h Byte_Per_Packet BytePerPacket = set by user *
RecBytePerPacket = 4092 (0xFFC)
048h
Packet_Per_Frame_Inq The value of this register depends on the following
registers:
• Image_Size
• Color_Coding_ID
• Byte_Per_Packet
04Ch
Unit_Position_Inq A102f: Hposunit = 1, Vposunit = 1
A102fc: Hposunit = 2, Vposunit = 2
054h **
Data_Depth
Indicates the effective data depth of the pixel in-
formation being transmitted from the camera.
The value of this register depends on the following
registers:
• Color_Coding_ID
In Format _7, Mode_0:
Color_Coding_ID Effective Bits
Data Depth Transmitted
ID = 0 (Mono 8) 8 8
ID = 9 (Raw 8) ** 8 8
ID = 5 (Mono 16) 12 16
ID = 10 (Raw 16) ** 12 16
ID = 2 (YUV 4:2:2) 8 16
058 **
Color_Filter_ID Identifies the order of the pixel colors transmitted out
of the camera on cameras equipped with an RGB
primary color filter (such as the Bayer filter used on
Basler A102fc cameras).
The A102fc supports the following color filter IDs:
• ID 0
• ID 1
• ID 2
• ID 3