User`s manual

Configuring the Camera
BASLER A102f 4-9
DRAFT
* This field is defined in version 1.31 of the IIDC specification.
81Ch Shutter Shutter settings range from 1 (0x001) to 4095
(0xFFF).
Exposure time = (shutter register value) x 20 µs
Default = 500 (0x1F4) = 10 ms for the A102f
= 562 (0x232) = 11.24 ms for the A102fc
820h
Gain Gain settings range from 192 (0x0C0) to 1023
(0x3FF) for all output modes except Mono 16. For
Mono 16, gain settings range from 192 (0x0C0) to
511 (0x1FF).
A setting of 0x0C0 results in a gain of 1x (0dB)
A setting of 0x3FF results in a gain of 35.5x (31 db)
Default = 210 (0x0D2) for the A102f
= 224 (0x0E0) for the A102fc
830h
Trigger_Mode Setting On_Off to:
0 = disable trigger use {= default}
1 = enable trigger use
Setting Trigger_Polarity to:
0 = low active {= default}
1 = high active
Setting Trigger_Source * to:
0 = ExtTrig on physical input port 0 {= default}
1 = ExtTrig on physical input port 1
2 = ExtTrig on physical input port 2
3 = ExtTrig on physical input port 3
7 = Software trigger
Setting Trigger_Mode to:
0 = mode 0 (programmable mode)
1 = mode 1 (level mode) {= default}
When an external trigger is used, trigger mode 0
and trigger mode 1 are both valid.
When a software trigger is used, only trigger mode
0 is valid.
The parameter portion of the register is ignored.
Offset Name Notes