User`s manual

Configuring the Camera
4-8
BASLER A102f
DRAFT
4.4.2 Control and Status Registers
Control and Status Registers for the Camera
* These registers are defined in version 1.31 of the IIDC specification.
Control and Status Registers for Features
Offset Name Notes
600h Cur_V_Frame_Rate / Revision Default = 0
604h
Cur_V_Mode Default = 0
608h
Cur_V_Format Default = Format 7
60Ch
Iso_Channel / Iso_Speed Default Channel =0
Default Speed = S400
614h
Iso_En / Continuous Shot Default = 0
61Ch
One_Shot / Multi_Shot Default = 0
Multi_Shot is not supported
62Ch *
Software_Trigger Write a 1 to set the trigger.
Self cleared when Trigger Mode = 0
630h *
Data_Depth Default = 8
Read only
Offset Name Notes
800h Brightness Brightness settings range from 0 to 255 (0x000 to
0x0FF).
Default = 16 (0x10) for the A102f
= 32 (0x20) for the A102fc
See Section 3.5.2 for more information on setting
the brightness.
80Ch
White_Balance The U_Value_or_B_Value setting adjusts the blue
level in the captured images. The setting ranges
from 16 (0x10) to 255 (0xFF). When set to 64
(0x40), this register has no effect on the image. Set-
tings lower than 64 make the images less blue. Set-
tings greater than 64 make the images more blue.
U_Value _or_B_Value default = 112 (0x70)
The V_Value_or_R_Value setting adjusts the red
level in the captured images. The setting ranges
from 16 (0x10) to 255 (0xFF). When set to 64, this
register has no effect on the image. Settings lower
than 64 make the images less red. Settings greater
than 64 make the images more red.
V_Value_or_R_Value default = 64 (0x40)