User`s manual

Camera Interface
BASLER A101
f 2-5
DRAFT
2.3 Camera Power
Power must be supplied to the camera via the IEEE 1394 cable. The camera requires +12 VDC
± 10%. Maximum power consumption is 5.0 W for the A101
f. Ripple must be less than 1%.
2.4 Status LEDs
Green LED
The green LED on the back of the camera is used to indicate whether power is being supplied to
the camera. When the green LED is out, it means that no power is present. When the green LED
is lit, it means that power is present.
Yellow LED
The yellow LED indicates signal integrity. In case of an error, blinking signals from the yellow LED
indicate that an error condition is present. See Section 6.1 for more information.
*
Keep in mind that the circuit used to light the green LED does not perform a range
check. If power to the camera is present but it is out of range, the LED may be lit but
the camera will not operate properly.