User`s manual

Video Data Output Modes
Basler sprint Mono Cameras 87
5.1.1 Setting the Video Data Output Mode
You can set the video data output mode with the Camera Configuration Tool Plus (CCT+) or by
using binary write commands from within your own application to set the camera’s control and
status registers (CSRs).
With the CCT+
With the CCT+ (see Section 7.1 on page 156), you use the Video Data Output Mode parameter in
the Output Mode parameters group to set the output mode.
By Setting CSRs
You select the video data output mode by writing the appropriate value to the Mode field of the Video
Data Output Mode CSR (see page 173).
See Section 7.2.2 on page 164 for an explanation of CSRs and Section 7.3.1 on page 197 for an
explanation of using read/write commands.