User`s manual

Line Acquisition Modes
58 Basler sprint Mono Cameras
3.7 Time Delayed Line Averaging
Acquisition Mode
The operation of the camera’s time delayed line averaging feature is essentially the same as the
time delayed line summing feature with one exception: after the pixel values have been summed,
each sum is divided by 2 (and rounded up if necessary).
For more information about time delayed line summing (see Section 3.5 on page 51).
Setting the Camera for Time Delayed Line Averaging Acquisition Mode
You can enable the time delayed line averaging acquisition mode by using the Camera
Configuration Tool Plus (CCT+) or by using binary write commands from within your own application
to set the camera’s control and status registers (CSRs).
With the CCT+
With the CCT+ (see Section 7.1 on page 156), use the Line Acquisition Mode parameter in the
Output Mode parameters group to set the line acquisition mode to Time Delayed Line Averaging -
Line A Delayed or to Time Delayed Line Averaging - Line B Delayed as desired.
By Setting CSRs
To enable the time delayed line averaging acquisition mode, write the appropriate value to the Mode
field of the Line Acquisition Mode CSR (see page 167).
Section 7.2.2 on page 164 explains CSRs and Section 7.3.1 on page 197 explains using read/write
commands.