User`s manual

Line Acquisition Modes
50 Basler sprint Mono Cameras
Setting the Camera for Vertical Binning
You can set the camera for vertical binning acquisition mode by using the Camera Configuration
Tool Plus (CCT+) or by using binary write commands from within your own application to set the
camera’s control and status registers (CSRs).
With the CCT+
With the CCT+ (see Section 7.1 on page 156), use the Line Acquisition Mode parameter in the
Output Mode parameters group to set the line acquisition mode to Vertical Binning.
By Setting CSRs
To enable vertical binning acquisition mode, write the appropriate value to the Mode field of the Line
Acquisition Mode CSR (see page 167).
Section 7.2.2 on page 164 explains CSRs and Section 7.3.1 on page 197 explains using read/write
commands.