User`s manual

Line Acquisition Modes
48 Basler sprint Mono Cameras
Setting the Camera for a Dual Line [Max 140 kHz] Acquisition Mode
You can set the camera for two line acquisition mode by using the Camera Configuration Tool Plus
(CCT+) or by using binary write commands from within your own application to set the camera’s
control and status registers (CSRs).
With the CCT+
With the CCT+ (see Section 7.1 on page 156), you use the Line Acquisition Mode parameter in the
Output Mode parameters group to set the line acquisition mode to Dual Line [Max 140 kHz] - Line
A First or to Dual Line [Max 140 kHz] - Line B First.
By Setting CSRs
You set the line acquisition mode to two line by writing the appropriate value to the Mode field of the
Line Acquisition Mode CSR (see page 167).
Section 7.2.2 on page 164 explains CSRs and Section 7.3.1 on page 197 explains using read/write
commands.