User`s manual

Line Acquisition Modes
40 Basler sprint Mono Cameras
3.2 Single Line [Max 70 kHz]
Acquisition Mode
When single line acquisition mode is active, the camera will only use line A. Each time a line
acquisition is triggered, only line A will be exposed. When line acquisition is complete (i.e., exposure
is finished), the pixel values from the single line will be read out of the sensor and transmitted from
the camera.
For more information about triggering line acquisition and controlling exposure, see Chapter 4 on
page 67.
The maximum line acquisition rate when the camera is set for this acquisition mode is 70 kHz at full
resolution. If the AOI feature is used, the maximum line acquisition rate may be higher. See
Section 6.2 on page 118 and Section 4.3 on page 74 for more information.
Setting the Camera for Single Line [Max 70 kHz] Acquisition Mode
You can set the camera for single line [max 70 kHz] acquisition mode by using the Camera
Configuration Tool Plus (CCT+) or by using binary write commands from within your own application
to set the camera’s control and status registers (CSRs).
With the CCT+
With the CCT+ (see Section 7.1 on page 156), you use the Line Acquisition Mode parameter in the
Output Mode parameters group to set the line acquisition mode to Single Line [Max 70 kHz].
By Setting CSRs
You set the line acquisition mode to single line by writing the appropriate value to the Mode field of
the Line Acquisition Mode CSR (see page 167).
Section 7.2.2 on page 164 explains CSRs and Section 7.3.1 on page 197 explains using read/write
commands.