User`s manual

Physical Interface
36 Basler sprint Mono Cameras
2.8.5 Serial to Frame Grabber
The Serial To Frame Grabber (SerTFG) output signal is an RS-644 LVDS signal as specified in the
Camera Link standard. The signal is output from the camera on pins 8 and 21 of MDR connector
one as specified in the standard and as shown in Table 5 on page 25 and in Figure 14 on page 32.
Signals from the SerTFG output are used during camera configuration. For more detailed
information about the serial connection, see Section 2.9 on page 37 and Section 7.3 on page 196.
Notes
Keep in mind that a change to the Camera Link clock speed is a parameter
change and that parameter changes are normally lost when the camera is
reset or switched off and back on. To avoid this, you can make changes to the
camera’s parameters, save the changed parameters to a "user set", and then
activate the user set. This will ensure that the changed parameters are saved
and are loaded into the camera at reset or power off/on. For more information
about saving and activating sets of parameters, see Section 6.12 on
page 149.
Lowering the clock speed from 80 MHz to 40 MHz may lower the camera’s
maximum allowed line rate. For more information about calculating the
maximum allowed line rate, see Section 4.3 on page 74.
Some frame grabbers are not compatible with an 80 MHz pixel clock speed.
Refer to the documentation for your frame grabber to determine if it is
compatible.