User`s manual

Revision History
Basler sprint Mono Cameras 219
AW00016206000 12 Sep 2008 Integrated the 8k camera models.
Updated contact addresses and phone numbers.
Updated the camera version ID number in Section 1.1 on page 1.
Replaced "input power" by "camera power" in Section 1.7 on page 20,
Section 2 on page 23, Section 6 on page 115, Section 7.2.1.1 on page 158,
and Section 8.3.1 on page 209.
Modified the labelling of the y axis of Figure 4 in Section 1.4 on page 10.
Updated the minimum high time of the ExSync signal in Section 2.7.2 on
page 33.
Corrected the recommendations of when to use Line A First and Line B
First modes in Section 3.3 on page 41.
Updated the calculations of the actual exposure time with ExSync edge
controlled mode and of the max. allowed programmed exposure time with
ExSync programmable mode in Section 4.1.3 on page 69.
Added a note about a decreased maximum line rate for the spA2048-
140km when operated with 8 tap output at 80:Mhz in Section 4.3 on
page 74 and Section 5.1 on page 85.
Updated the calculation for the max. allowed line rate according to
formula 1 in Section 4.3.2 on page 80.
Added Section 4.3.4 on page 82: "Camera Settings for the Maximum
Specified Line Rate".
Updated and added line valid delay data in Section 5.2.1.2 on page 93,
Section 5.2.2.2 on page 102, and Section 5.2.3.2 on page 112.
Removed the incorrect information that the line counter is reset whenever
the stamp feature is disabled from Section 6.5 on page 136.
Added note about data depth of the transmitted data when using the lookup
table feature with a 10 bit or 12 bit video data output mode in Section 6.6
on page 141.
Added the name "FactorySet" in Section 6.12 on page 149.
Added note not to use the CCT+ in demo mode in Section 7.1 on page 156.
Removed the Microcontroller Firmware Version Inquiry, the FPGA
Firmware Version Inquiry, and the FPGA Configuration Version Inquiry
registers in Section 7.2.1.1 on page 158.
Added the Firmware Version Inquiry register in Section 7.2.1.1 on
page 158.
Additions and corrections in the Configuration Set and Shading Values
CSRs in Section 7.2.3.4 on page 194:
 Added "Erase" and corrected the enumeration for "Activate" in the
Control fields.
 Corrected the value for "This is an activated file" in the Info fields.
 Added the allowed file names to the File Name fields.
Updated the minimum difference between the exposure time and the
ExSync period in Section 8.3.1 on page 209.
Minor corrections and modification throughout the manual.
Doc. ID Number Date Changes