User`s manual

Features
Basler sprint Mono Cameras 153
6.12.3 Which Configuration Set File will Load at Startup
or at Reset?
On the initial wake-up after delivery, the camera loads the factory configuration set into the work set.
At each subsequent power on or reset, the configuration set file that was last activated is loaded
into the work set.
If there is no activated file, the factory set file will be loaded into the work set.
6.12.4 Downloading Configuration Set Files to Your PC
Once you have saved user sets to the user set files in your camera, you can download the user set
files to your PC. You can also download the factory set file to your PC.
Using the download function together with the upload function that is described on the next page is
useful if you want to transfer a user set file from one camera to another camera of the same type.
You can download a user set file or the factory set file by using the Camera Configuration Tool Plus
(CCT+) or by using binary read/write commands from within your own application to set the
camera’s control and status registers (CSRs).
With the CCT+
With the CCT+ (see Section 7.1 on page 156), you use the File Name Select parameter in the
Configuration Set Files parameters group to select a user set file or the factory set file and use the
Download button to download the selected file.
By Setting CSRs
You can download a user set file or the factory set file by writing values to the configuration set bulk
data CSR. Section 7.2.3 on page 188 explains the bulk data CSRs and Section 7.2.3.3 on page 191
explains how to use the CSRs to download a file. Section 7.3.1 on page 197 explains using read/
write commands.