User`s manual

Features
138 Basler sprint Mono Cameras
The table below lists the function of each stamp pixel. A more detailed explanation of how to
interpret the pixel values follows the table.
Stamp Pixels S1 and S2
Stamp pixel S1 always has a fixed value of 0xAA.
If the camera is set for one of the dual line acquisition modes and if the pixel values are from line
A, stamp pixel S2 will have a fixed value of 0x55.
If the camera is set for one of the dual line acquisition modes and if the pixel values are from line
B, stamp pixel S2 will have a fixed value of 0x57.
If the camera is set for any other line acquisition mode, stamp pixel S2 will have a fixed value of
0x55.
S1 and S2 can be used as a data integrity check. They can also be used to find the start of the stamp
pixels.
For more information about line acquisition modes, see Section 3 on page 39.
Position Function
S1 A fixed value of 0xAA
S2 A fixed value of 0x55 (with camera set for dual line acquisition mode and pixels from line A)
A fixed value of 0x57 (with camera set for dual line acquisition mode and pixels from line B)
A fixed value of 0x55 (with camera set for any other acquisition mode)
S3 Line Counter (LSByte)
S4 Line Counter (MSByte)
S5 Line Sum (LSByte)
S6 Line Sum (MidByte)
S7 Line Sum (MSByte)
S8 Reserved
S9 Total High Pixels (LSByte)
S10 Total High Pixels (MSByte)
S11 Total Low Pixels (LSByte)
S12 Total Low Pixels (MSByte)
S13 Contrast Value (LSByte)
S14 Contrast Value (MidByte)
S15 Contrast Value (MSByte)
S16 Reserved
Table 28: Stamp Pixel Functions