User`s manual

Specifications, Requirements, and Precautions
4 Basler sprint Mono Cameras
1.2.3 Camera Models with 8k Pixels
Specification spL8192-20km spL8192-39km spL8192-70km
Sensor Size 2 lines - 8192 pixels per line
Sensor Type Monochrome linear CMOS
Pixel Size 10 µm x 10 µm
Camera Link
Clock Speed
40 MHz 40 MHz or 80 MHz (switchable)
Maximum
Line Rate
19.4 kHz 38.6 kHz 70 kHz
Minimum
Line Rate
1 kHz
Data Output Type Camera Link medium
config.
Camera Link medium/full configuration
Data Output
Modes
2 tap - 8, 10, or 12 bit
4 tap - 8, 10, or 12 bit
2 tap - 8, 10, or 12 bit
4 tap - 8, 10, or 12 bit
8 tap - 8 bit
Synchronization Via external trigger signal or free run
Exposure Control Edge controlled, level controlled, or programmable
Gain and Offset Programmable via a serial link
Connectors One, 6-pin, Hirose micro-miniature receptacle
Two, 26-pin, female MDR connectors
Power
Requirements
+12 VDC (± 10%)
Max 10.0 W @ 12 VDC when set for the single line acquisition mode
Max 13.5 W @ 12 VDC when set for all other line acquisition modes
Lens Adapters Sets of optical components including a helical mount or a lens mount with V-Basler
interface
Housing Size
(L x W x H)
49.0 mm x 92.0 mm x 102.0 mm (without optical components or connectors)
53.5 mm x 92.0 mm x 102.0 mm (without optical components, with connectors)
Weight ~ 580 g (without optical components)
~ 1480 g (with UNIFOC 100/95_/_V-Basler helical mount)
~ 780 g (with M58 x 0.75_/_V-Basler lens mount)
Table 3: General Specifications for 8k Cameras