User`s manual

Specifications, Requirements, and Precautions
Basler sprint Mono Cameras 3
1.2.2 Camera Models with 4k Pixels
Specification spL4096-20km spL4096-39km spL4096-70km spL4096-140km
Sensor Size 2 lines - 4096 pixels per line
Sensor Type Monochrome linear CMOS
Pixel Size 10 µm x 10 µm
Camera Link
Clock Speed
40 MHz 40 MHz or 80 MHz (switchable)
Maximum
Line Rate
19.4 kHz 38.6 kHz 70 kHz 140 kHz (in dual
line acquisition
mode)
Minimum
Line Rate
1 kHz
Data Output Type Camera Link base config. Camera Link medium/full configuration
Data Output
Modes
2 tap - 8, 10, or 12 bit 2 tap - 8, 10, or 12 bit
4 tap - 8, 10, or 12 bit
2 tap - 8, 10, or 12 bit
4 tap - 8, 10, or 12 bit
8 tap - 8 bit
Synchronization Via external trigger signal or free run
Exposure Control Edge controlled, level controlled, or programmable
Gain and Offset Programmable via a serial link
Connectors One, 6-pin, Hirose micro-
miniature receptacle
One, 26-pin, female MDR
connector
One, 6-pin, Hirose micro-miniature receptacle
Two, 26-pin, female MDR connectors
Power
Requirements
+12 VDC (± 10%)
Max 7.0 W @ 12 VDC when set for the single line acquisition mode
Max 10.0 W @ 12 VDC when set for all other line acquisition modes
Lens Adapter F-mount, M42
Housing Size
(L x W x H)
48.0 mm x 87.0 mm x 62.0 mm (without lens adapter or connectors)
84.9 mm x 87.0 mm x 62.0 mm (with F-mount adapter and connectors)
Weight ~ 360 g (without lens adapter)
Table 2: General Specifications for 4k Cameras