User`s manual

Features
Basler sprint Mono Cameras 117
Setting the Offset
You can set the offset with the Camera Configuration Tool Plus (CCT+) or by using binary write
commands from within your own application to set the camera’s control and status registers
(CSRs).
With the CCT+
With the CCT+ (see Section 7.1 on page 156), you use the Offset parameter in the Gain & Offset
parameters group to set the offset.
By Setting CSRs
You set the offset by writing a value in digital numbers to the Absolute Offset field or by writing an
integer value to the Raw Offset field of the Offset CSR (see page 174).
Section 7.2.2 on page 164 explains CSRs and the difference between using the “absolute” field and
the “raw” field in a CSR. Section 7.3.1 on page 197 explains using read/write commands.