User`s manual

Specifications, Requirements, and Precautions
2 Basler sprint Mono Cameras
1.2 General Specifications
1.2.1 Camera Models with 2k Pixels
Specification spL2048-39km spL2048-70km spL2048-140km
Sensor Size 2 lines - 2048 pixels per line
Sensor Type Monochrome linear CMOS
Pixel Size 10 µm x 10 µm
Camera Link
Clock Speed
40 MHz 40 MHz or 80 MHz (switchable)
Maximum
Line Rate
38.6 kHz 70 kHz 140 kHz (in dual line
acquisition mode)
Minimum
Line Rate
1 kHz
Data Output Type Camera Link base configuration Camera Link medium/full
configuration
Data Output Modes 2 tap - 8, 10, or 12 bit 2 tap - 8, 10, or 12 bit
4 tap - 8, 10, or 12 bit
8 tap - 8 bit
Synchronization Via external trigger signal or free run
Exposure Control Edge controlled, level controlled, or programmable
Gain and Offset Programmable via a serial link
Connectors One, 6-pin, Hirose micro-miniature receptacle
One, 26-pin, female MDR connectors
One, 6-pin, Hirose micro-
miniature receptacle
Two, 26-pin, female MDR
connector
Power
Requirements
+12 VDC (± 10%)
Max 5.0 W @ 12 VDC when set for the single line acquisition mode
Max 6.0 W @ 12 VDC when set for all other line acquisition modes
Lens Adapter F-mount, M42, C-Mount (see Section 1.3 on page 5)
Housing Size
(L x W x H)
48.0 mm x 87.0 mm x 62.0 mm (without lens adapter or connectors)
84.9 mm x 87.0 mm x 62.0 mm (with F-mount adapter and connectors)
Weight ~ 360 g (without lens adapter)
Table 1: General Specifications for 2k Cameras