User`s manual

Configuring the Camera
Basler IP Camera 17
Frame Rate Mode - Sets the rate at which the camera’s sensor will
capture frames (images). For example, selecting 15 FPS means that
the camera’s imaging sensor will capture 15 frames per second.
Note that on some camera models, typically those with large imaging
sensors, the maximum rate at which the sensor can capture images
(i.e., the frame rate) is limited. On these cameras, if you decrease the
height of the sensor AOI, the rate at which the sensor can capture
images will increase. So if you decrease the setting for the AOI
Height parameter, you may see an increase in the maximum setting
available for the Frame Rate Mode parameter.
Also note that the Manual setting is not intended for field use and
should be avoided.
Sensor AOI Left - As shown in Figure 3 on page 16, sets the left
offset (in pixels) for the sensor AOI, i.e., how far the sensor AOI will
be offset from the left edge of the sensor.
See also, the sensor AOI Editor description on the next page.
Sensor AOI Top - As shown in Figure 3 on page 16, sets the top offset (in pixels) for the sensor
AOI, i.e., how far the sensor AOI will be offset from the top edge of the sensor.
See also, the sensor AOI Editor description on the next page.
Sensor AOI Width - As shown in Figure 3 on page 16, sets the width (in pixels) of the sensor AOI.
See also, the sensor AOI Editor description on the next page.
Sensor AOI Height - As shown in Figure 3 on page 16, sets the height (in pixels) of the sensor
AOI. See also the sensor AOI Editor description on the next page.