User`s manual

Revision History
Basler IP Camera 87
AW00072106000 28 Jan 2010 Updated the firmware version level stated in Section 1.1 on page 1.
Updated the WEEE information in Section 1.2 on page 2.
Updated the description of the normal mode and the configuration mode in
Section 3.1 on page 7.
Added new settings for the Iris Mode parameter on page 13.
Updated the introduction to streaming parameters in Section 3.4 on
page 18.
Updated the description of the Test Image Mode parameter on page 20.
Added a description of the email Text Overlay button and the Email From
parameter to page 38.
Added a description of the FTP Text Overlay button and the FTP Remote
Dir parameter to page 39.
Added a description of how to add overlay text to alarm email and FTP
images to page 40.
Clarified the allowed address range for the Multicast IP parameter on
page 43.
Added Section 3.7.3 on page 44 describing the new QoS parameters.
Added the new Output Pin Function parameter to Section 3.8.1 on page 45.
Updated the time zone codes in Table 2 on page 55.
Added Section 4 on page 63 describing the new reset tool.
Updated the description of the IR-cut filter announce feature on page 73.
Updated numerous screen shots to reflect new parameters and usability
improvements.
AW00072107000 25 Jun 2010 Updated the contact information on the inside of the front cover.
Updated the information in the Firmware portion of Section 1.1 on page 1
regarding the latest version of camera firmware.
Added information to the Firmware portion of Section 1.1 on page 1
regarding the latest version of the BIP Finder software.
Added a warning to Section 1.2 on page 2 regarding explosive
atmospheres.
Updated the Exposure tab screen shot in Section 3.3.1 on page 12.
Added the description of the new Anti-Flicker parameter to page 13.
Added information to the Exposure Time Limit parameter description on
page 13 and the Gain Limit parameter on page 14 to indicate that these two
parameters can be impacted by the Anti-Flicker parameter setting.
Updated the Appearance tab screen shot in Section 3.3.2 on page 15.
Renamed one of the settings on page 15 for the White Balance Mode
parameter to "Automatic Preset".
Added the new Red Gain and Blue Gain parameter descriptions to page 16.
Updated the description of the "Reset to Factory Defaults" button on
page 56.
Added information about the latest version of the BIP Finder software and
the new "Keep all settings" capability to the description of the firmware
update procedure that starts on page 59.
Doc. ID Number Date Changes