User`s manual

Configuring the Camera
56 Basler IP Camera
3.10.3 Management Tab
Click the Show System Log button to display a log of system messages.
Click the Restart the Camera button to reboot the camera. When the reboot
is complete, the web client will reopen in your browser. Restarting your
camera will not change any parameter settings
Click the Reset to Factory Defaults button to reset the camera to factory
defaults. Before using this button, be absolutely sure that this is what you
want to do.
After you click the Reset to Factory Defaults button, you will see an Are you
sure? message as shown below:
 If the Keep Network/User Settings check box is checked, the camera will
reset all of the configuration settings except the network settings and the
user settings.
 If the Keep Network/User Settings check box is cleared, the camera will
reset all of the configuration settings including the network settings and
the user settings.
Depending on how your network is configured, if you reset the network
settings, you may not be able to access the camera via your web
browser after you do the reset. If this is the case, use the BIP Finder
software to connect to the camera as described in the Basler IP Camera
Installation Guide.
Show System Log
Restart the Camera
Reset to Factory Defaults