User`s manual

Configuring the Camera
44 Basler IP Camera
3.7.3 QoS Tab
The parameters on this tab are used to set network traffic prioritization settings, commonly known
as QoS or Quality of Service settings. Note that these settings will only have an effect on networks
where all network switches and routers support QoS.
Normally, these settings should only be adjusted by a network administrator.
HTTP DSCP - Sets the HTTP DSCP (differentiated services code
point) value.
RTSP DSCP - Sets the RTSP DSCP (differentiated services code
point) value.
Alarm DSCP - Sets the alarm DSCP (differentiated services code
point) value.
Click the Commit button save any changes you have made to the QoS settings.
Click the Revert button to cancel any changes you have made to the QoS settings. The
settings will revert to what they were the last time that the Commit button was clicked.
3.7.4 Network I/O Tab
Network Traffic Out - Indicates the current amount of outgoing
network traffic in kilobits per second.
Network Traffic In - Indicates the current amount of incoming
network traffic in kilobits per second.
Commit
Revert