User`s manual

Configuring the Camera
36 Basler IP Camera
3.6 Alarm Handling Parameters
The parameters in the Alarm Handling group are used to select the sources that can declare an
alarm condition and to control the actions that will be taken when an alarm condition is declared.
3.6.1 Alarm Sources Section
The alarm sources section of the alarm handling parameters group is used to select the sources
that can declare an alarm condition.
User Trigger Tab
Source Enable - Check the Source Enable box on the User Trigger
tab to enable the user trigger as a source for declaring an alarm
condition.
Digital In Tab
Source Enable - Check the Source Enable box on the Digital In tab
to enable the camera’s digital input line as a source for declaring an
alarm condition.
If the digital input line is enabled as an alarm source and the line
becomes active, an alarm condition will be declared.
Motion Tab
Source Enable - Check the Source Enable box on the Motion tab to
enable motion detection as a source for declaring an alarm condition.
If motion detection is enabled as an alarm source and motion is
detected, an alarm condition will be declared.
(In order to use motion detection as an alarm source, motion
detection must be enabled. See Section 3.5 on page 34 for more
information about motion detection.)
If the user trigger is enabled as an alarm source, you
can click the User Trigger button to declare an alarm
condition.
User Trigger