User`s manual

BASLER A302f i

DRAFT

Revision History

Doc. ID Number Date Changes

DA039301 6-Feb.-2001 Initial release.

DA039302

18-Apr.-2001 Made numerous small changes to grammar and phrasing.

Added connector information in Section 2.1.3.

Added ripple specification to Table 1-1 and Section 2.3.

Added Section 4.6 containing information about how to access firmware

version numbers.

DA039303

25-July-2001 Updated the camera model information in Section 1.1.

Moved the information about color creation in the

A302fc to a separate

section (Section 3.10) and added information about YUV output, white

balance, and using a color camera in monochrome modes. The YUV out-

put and white balance features are available on color cameras with an ID

number of 1XXX13055 or higher

Corrected the notebox at the top of page 3-14.

Updated the list of available output formats and modes in Section 3.11.

Updated the note for register 80CH on page 4-6.

Removed the chapter on camera installation from this manual. The in-

stallation information now appears only in the

A302f Installation Guide.

DA039304

20-May-2002 Corrected the device information in Section 2.2.3 and Figure 2-3.

Updated the exposure control information in Section 3.2.3 to specify the

use of rising edge triggering.

Deleted the detailed timing explanations from Sections 3.2.2 and 3.2.3.

Added Section 3.2.4 containing information about recommended meth-

ods for exposure start control.

Updated Figure 3-11 in Section 3.7 and added information about mini-

mum AOI size to the note box.

Corrected the descriptions of test image one and test image two in Sec-

tion 3.8.

Updated the information about shading correction in Section 3.9. This

section now directs the user to the BCAM 1394 Driver viewer program to

work with shading correction.

Corrected Figure 3-14 in Section 3.10.

Added information about the BCAM driver to the introduction on page 4-

Updated the information about advanced features registers in Section

4.5.