Specifications

2
2-1
Installation Verification Operator Manual 122996-163
INSTALLATION VERIFICATION
2.1 General An equipment drawing (122-998-267 or 122-998-283), showing all
utility and space requirements, was supplied with the Basil
®
3600
Bedding Dispenser. The clearance space specified on the equip-
ment drawing is necessary for ease of installation and to help ensure
proper operation and maintenance of equipment. If document is
missing or misplaced, contact STERIS, giving the serial and model
numbers of the bedding dispenser. A replacement copy will be sent
promptly.
2.2 Installation
Checklist
After bedding dispenser has been installed by a qualified service
technician, complete the following checklist to help ensure complete
and correct installation. If desired, contact STERIS to schedule a
demonstration of proper equipment operation.
❑ Disconnect switch (not by STERIS), capable of being locked in
OFF position only, is installed in the electrical supply line in the
same room as the bedding dispenser, and within 10 feet (3 m) of
the electrical control box.
❑ Bedding dispenser is positioned, as shown on the equipment
drawing, with the required service clearance space and in rela-
tion to building supply lines.
❑ Electrical supply for bedding dispenser is as specified on the
equipment drawing.
❑ Both conveyor motors (loading/unloading drive motor and bed-
ding conveyor motor) rotate in the direction shown by the arrow.
❑ Verify exhaust guard, elbow and dust bag are in proper position.
❑ Verify cage flip-over system is firmly installed and in proper posi-
tion.
❑ Verify photoelectric switch is properly installed at the end of the
unload conveyor.