Specifications

5-10
122996-163 Operator Manual Routine Maintenance
5.4.3 Adjust Dispenser Take-
Up Bearings
See Figures 5-1 and 5-7.
1. Lock electrical disconnect switch in OFF position.
2. Locate dispenser take-up bearings (see Figure 5-1).
3. Adjust take-up bearings on dispenser belt, as needed, for ten-
sion and proper tracking. Turn clockwise to tighten, counter-
clockwise to loosen (see Figure 5-7).
4. Ensure adjustment distance is exactly the same on both sides of
dispenser belt. Do not overtighten.
5. Unlock electrical disconnect switch and position to ON.
WARNING–PERSONAL INJURY
AND/OR EQUIPMENT DAMAGE
HAZARD: Repairs and adjust-
ments to this equipment must
be made only by STERIS or
STERIS-trained service person-
nel. Non-routine maintenance
performed by unqualified per-
sonnel or installation of unau-
thorized parts could cause
personal injury, result in
improper equipment perfor-
mance, void the warranty or
result in costly damage. Con-
tact STERIS regarding service
options.
WARNING–ELECTRIC SHOCK
AND/OR BURN HAZARD:
Disconnect all utilities to dis-
penser before servicing. Do
not service dispenser unless
all utilities have been properly
locked out. Always follow local
lockout-tagout and electrical
safety-related work practice
standards.
Figure 5-7. Adjust Dispenser Take-Up Bearings
Take-Up Bearing
Adjustment Rod