Specifications

5-3
Routine Maintenance Operator Manual 122996-163
5.3 Weekly Cleaning
5.3.1 Clean Cage Conveyor
Rollers
See Figures 5-1, 5-2 and 5-3.
Once a week, cage conveyor rollers must be thoroughly cleaned to
remove gross soil and debris (see Figure 5-1).
1. Before cleaning or servicing cage conveyor rollers, remove as
follows:
a. Remove holding collar from long axle, located on removable
end of roller (see Figure 5-3).
b. Place left hand on removable roller end cap, to hold firmly in
place on frame (see Figure 5-3).
c. Slide roller on axle towards removable end.
d. Lift fixed end up and away from short axle (see Figure 5-2).
e. Repeat Steps a to d for each roller to be removed.
2. Clean rollers in hot water using a mild detergent.
3. Rinse under running water.
4. Dry each roller using a clean, dry, lint-free cloth.
5. Repeat for each roller.
6. Apply stainless-steel cleaner for general stains or stainless-steel
stain remover for stubborn stains.
7. Using a damp cloth or sponge, rub in a back-and-forth motion, in
same direction as surface grain.
8. Polish surface with a clean, dry, lint-free cloth, using stainless-
steel polish, if desired.
9. After cleaning conveyor rollers, reassemble as follows:
a. Insert roller on long axle (pulling roller towards frame).
b. Push roller assembly firmly against roller cap (see Figure 5-3).
NOTE: Ensure O-ring is correctly placed and in good
condition. If not, replace O-ring. Refer to S
ECTION 7,
R
EPLACEMENT PARTS AND PRODUCTS, for ordering information.
c. Turn holding collar until it locks in position over shaft.
d. Align roller on fixed end cap. Slide and push firmly into place
(see Figure 5-2).
e. Snap holding collar over axle (see Figure 5-3).
f. Repeat Steps a to e for each roller to be reinstalled.
WARNING–ELECTRIC SHOCK
AND/OR BURN HAZARD:
Disconnect all utilities to dis-
penser before servicing. Do
not service dispenser unless
all utilities have been properly
locked out. Always follow local
lockout-tagout and electrical
safety-related work practice
standards.
CAUTION – POSSIBLE EQUIP-
MENT DAMAGE:
• Do not wash conveyor rollers
in water exceeding 140
°F
(60
°C).
• Use non-abrasive cleaners
when cleaning dispenser.
Follow directions on con-
tainer and rub in a back-
and forth motion (in same
direction as surface grain).
Abrasive cleaners are harm-
ful to stainless steel.