Service manual

GF Health Products, Inc. - www.grahamfield.com Zenith 7000 Service Manual 999-0843-190B-APRIL 2013
9
UNPACKING THE BED
•
Make sure all parts/components are included.
•
Check all bed components for obvious damage.
•
Inspect the Power Supply Cord for any cuts and/
or damage.
•
Check to see all actuator/motor cables are routed
and connected
properly to the
control box.
DISCARD
1. Middle Foam Block
2. Large Block
3. Large Cable Tie - CUT
4. Notched 2 x 4 Board
5. Small Side Blocks
6. Foam Wrapping
7. End Caps with Foam
8. Notched Leg Foam
9. Small Cable Tie - CUT
KEEP
10. Wireform Wallsaver
11. Two Mattress Retainers
12. Service Manual/Documents
13. Pendant Holster
(attached to pendant)
NOTE:
END OF POWER CABLE IS COILED
FOR SHIPPING AND TIED, WITH
CABLE TIE, TO GRID WIRE ALONG
WITH PENDANT, PENDANT CABLE
& HOLSTER.
PLEASE CUT AND DISCARD CABLE
TIE AROUND CABLES WHEN YOU
UN-PACK THE BED.
ALSO
DISCARD TOP
AND BOTTOM
CARTONS
12
4
3
1
2
2
6
6
7
7
10
11
11
8
9
5
13
8
Cut and
discard
cable tie.
Zenith SeRieS