Service manual

GF Health Products, Inc. - www.grahamfield.com Zenith 7000 Service Manual 999-0843-190B-APRIL 2013

Pendant Holster

999-0791-000

comes standard

with the Zenith

7000 bed.

The Pendant

cable has a

phone jack

connector.

HAND PENDANT

Part #999-0808-305

(Bed comes shipped with

Alligator Clip attached to

pendant cable. To order

a replacement pendant,

please see page 25.)

HAND PENDANT OPERATION

1 HEAD DECK ANGLE UP BUTTON

2 HEAD DECK ANGLE DOWN BUTTON

3 HI/LO UP BUTTON (RAISE ENTIRE BED)

4 HI/LO DOWN BUTTON (LOWER ENTIRE BED)

5 KNEE & FOOT DECK ANGLE UP BUTTON

6 KNEE & FOOT DECK ANGLE DOWN BUTTON

ZENITH 7000 PENDANT/HAND CONTROLLER OPERATION

NOTE:

THE ZENITH 7000 PENDANT CAN BE PLUGGED INTO THE T-CABLE PLUGS ON EITHER SIDE OF THE BED FOR

EASY ACCESS. THE OPPOSITE SIDE OF THE T-CABLE SHOULD ALWAYS HAVE THE PROVIDED CAP ATTACHED

FOR SAFETY.

IN ORDER TO MAXIMIZE THE EASE OF USE, AS WELL AS THE LONGEVITY OF THE ZENITH BED, THE MICRO-

PROCESSOR CONTROLLED CONTROL SYSTEM MONITORS ALL HANDSET AND NURSE CONTROL INPUTS. IT IS

INTENDED FOR USE BY THE PATIENT TO MAXIMIZE COMFORT OR BY THE CAREGIVER FOR REPOSITIONING.

TO DETER MISUSE BY A PATIENT, IF THE SYSTEM DETECTS REPEATED BUTTON OPERATIONS, IT WILL BLOCK

THE NEXT SIGNALS TO ENSURE THE WELLBEING OF THE PATIENT AND TO PROTECT THE SYSTEM. SHOULD

THIS OCCUR, THE USER WILL NOTICE A TWO (2) SECOND DELAY WHEN DEPRESSING A FUNCTION OR CAN WAIT

FOR TWO (2) SECONDS BEFORE OPERATING THE BED AGAIN.

Zenith SeRieS

The hand controller comes standard on the Zenith 7000 series and can

be plugged into either side of the bed. The plug features a

lock-on cap. A pendant holster for attaching to optional

assist devices is also provided.