Service manual

DISCARD TOP
AND BOTTOM
CARTONS
12
4
3
1
2
2
6
6
7
7
10
11
11
8
9
5
13
8
Cut and
discard
cable tie.
UNPACKING THE BED
• Ensure all parts/components are included.
• Check all bed components for obvious damage.
• Inspect the Power Cord for cuts or damage.
• Ensure all actuator/motor cables are routed
and connected properly to the control box.
DISCARD
1. Middle Foam Block
2. Large Block
3. Large Cable Tie - CUT
4. Notched 2 x 4 Board
5. Small Side Blocks
6. Foam Wrapping
7. End Caps with Foam
8. Notched Leg Foam
9. Small Cable Tie - CUT
KEEP
10. Wireform Wallsaver
11. Two Mattress Retainers
12. Service Manual/Documents
13. Hand Control Pendant Holster
NOTE:
END OF POWER CABLE IS
COILED FOR SHIPPING AND
TIED, WITH CABLE TIE, TO GRID
WIRE WITH HAND CONTROL
PENDANT, PENDANT CABLE AND
HOLSTER.
CUT AND DISCARD CABLE TIE
AROUND CABLES WHEN YOU
UNPACK THE BED.
SECTION A: BED SETUP INSTRUCTIONS
GF Health Products, Inc. - www.grahameld.com Zenith 7000 Service Manual 999-0843-190E
ZENITH SERIES
8