Service manual
OPTIONAL TRAPEZE SUPPORT INSTALLATION
(THE TRAPEZE SUPPORT IS ATTACHED TO THE HEAD SECTION OF THE BED.)
ORDER KIT NUMBER ZA79000
Trapeze Unit ZA78100
(includes the bar, chain,
triangle, and support)
is ordered separately.
Use first holes in
Trapeze Support
to mount to main
frame tubes.
USE SAME CLEVIS PINS AND HAIR PIN CLIPS
THAT WERE USED TO CONNECT HEADBOARD
TO MOUNTING TUBES.
Use third hole
from the end of the
main frame tubes.
1. Begin by removing the headboard panel assembly
(#2), if previously assembled to the bed, by pulling
out the two Clevis Pins and two Hair Pin Clips that
attach the main frame tubes to the headboard’s
mounting tubes. Set all pins aside for later use.
2. Detach the headboard panel from the mounting tubes
by unscrewing the four 40mm long Socket Head Cap
Screws that fasten the board to the tubes (these will
be replaced with the longer Phillips Head Pan Screws
from the trapeze adaptor hardware bag). Do not
remove the four 1/4-20 inserts (#3) from the board.
They will be used again to mount the board to the
trapeze support.
3. Assemble the Trapeze Support (#1) to the main
frame tubes using the two Clevis Pins and Hair Pin
Clips you removed in Step 1. The rst holes in the
Trapeze tubes must line up with the fourth hole
from the end in the main frame tubes as shown;
the main frame shown is for 80" deck.
4. Insert the 1/4-20 x 2.50" Carriage Bolt (#5) into the
vertical support as shown and fasten with a 1/4-20
Hex Head Lock Nut (#6). Both parts should be in the
hardware bag.
5. Assemble the headboard to the inside of the Trapeze
Support so that the side of the headboard with the
inserts is facing away from the Trapeze Support.
From the outside, insert the four 1/4-20 x 1.75" long
Machine Screws (#4) from the hardware bag through
the holes in the Trapeze Support, screwing them into
the inserts in the headboard.
GF Health Products, Inc. - www.grahameld.com Zenith 7000 Service Manual 999-0843-190E
ZENITH SERIES
17