Service manual

ORDER PLASTIC RAIL KIT #ZA84200,
WHICH INCLUDES A RIGHT AND LEFT HALF
RAIL, FOUR LANYARD ASSEMBLIES, AND TWO
PHILLIPS SCREWS (OR TWO OPTIONAL HEX
HEAD SCREWS). ORDER BAG #999-0842-905
FOR JUST THE REPLACEMENT HARDWARE.
THE PLASTIC RAIL CAN BE INSTALLED ON
EITHER THE HEAD OR FOOT END OF 80"
BEDS. IT SHOULD ONLY BE INSTALLED ON
THE HEAD END OF 76" BEDS.
RH Plastic Half Rail
Assembly (#2)
Head Deck (#1)
Small
Hole
TOWARD CENTER
OF BED
Straight
Edge toward
Head End
Lanyard
Assembly (#3)
Lanyard
Assembly (#3)
Phillips
Screw (#4)
HEAD END
OPTIONAL PLASTIC HALF RAIL INSTALLATION AND OPERATION
KIT ZA84200 - (ILLUSTRATION SHOWS RAIL POSITIONED ON RIGHT SIDE OF BED)
1. Position the Plastic Half Rail (#2) as shown, with the taller, straight
edge toward the head end of the bed and arms angled toward the
center of the bed.
2. From the outside, insert the two welded grooved pins on the
rail arms into the two large holes in the side of the head deck.
3. From the inside, install the metal hair pin clip end of the Lanyard
Assembly (#3) onto the exposed grooves at the end of the pins.
4. Position the other terminal end of the Lanyard
Assemblies (#3) over the small hole on the
inside of the deck frame. Secure with a
small Phillips Screw (#4).
PLASTIC HALF RAIL OPERATION
SLEEP
SURFACE
SLEEP
SURFACE
TO AVOID PINCHING FINGERS,
HOLD THE HALF RAIL FROM THE
TOP WITH ONE HAND AND
CAREFULLY DEPRESS THE BLACK
RELEASE LEVER WITH THE OTHER.
ENSURE THERE ARE NO OBJECTS IN
THE WAY THAT MAY HINDER THE
FULL MOVEMENT OF THE RAIL.
TO AVOID PERSONAL INJURY,
ENSURE THE HALF RAIL IS
ALWAYS IN THE FULL UP
LOCKED POSITION WHENEVER
RESIDENT/PATIENT IS LEFT
UNATTENDED.
POWERED AIR MATTRESS SURFACES
MAY POSE A RISK OF ENTRAPMENT.
PRIOR TO USE, ENSURE THE
THERAPEUTIC BENEFITS
OUTWEIGH THE RISK OF
ENTRAPMENT.
!! !
GF Health Products, Inc. - www.grahameld.com Zenith 7000 Service Manual 999-0843-190E
ZENITH SERIES
16