Service manual
DETAIL A:
STAFF CONTROL
CABLE CONNECTION
DETAIL B:
ENSURE LOCK END
CAPS ARE SCREWED
ON SECURELY
SEE PAGE 9 OF THIS
MANUAL FOR PROPER
ASSEMBLY OF ELBOW
MOUNTING BRACKETS
(TUBES) AND FOOTBOARD
Loop Male Staff Control Cable
and cable tie through mounting
tube hole with Female Staff
Control Cable
Phillips Screws
attach Shroud
and Staff Control
Assembly from
inside of board
Cable Tie Staff
Control Cables
to right Mounting
Tube
Shroud
(Cable Cover)
Staff Control
Assembly
Footboard
with cutout
Female end of Staff Control Cable -
plugs into T-Cable
End of T-Cable at foot end - WHITE
(“T” runs on either side of Seat Pan
for attaching your Hand Controller)
Male end of Staff Control Cable -
plugs into short Black Control Cable
Short Black Control Cable running
from Control Box
FOOT
END
PLUGGING IN THE FOOTBOARD STAFF CONTROL
STEP 1 - ATTACHING THE FOOTBOARD
You can order an optional Staff Control for the Zenith 7000 which includes a Staff Control Assembly
and Shroud Cover pre-installed on the Footboard at the manufacturing facility.
To attach the Footboard assembly (with Staff Control)
to the main frame rails, see the instructions on
page 9 of this manual.
STEP 2 - CONNECTING THE CABLES:
REFER TO DETAIL A BELOW
1. At the foot end, unplug the Black Staff Control
cable from the end of the T-Cable (cables were
attached for shipping).
2. Insert the phone jack plug in the male end of
the staff control cable into the cylindrical plug
of the Black Control Cable that extends out
the foot end. Ensure the phone jack is
positioned properly inside the cable.
3. Insert the T-Cable end (extending out the foot
end with phone jack) into the cylindrical plug
of the female staff control cable. Ensure
the phone plug is seated properly
inside the female plug.
4. Screw on the round lock onto the
Staff Control’s female plug and
short Black Control Cable plug
(see DETAIL B).
GF Health Products, Inc. - www.grahameld.com Zenith 7000 Service Manual 999-0843-190E
ZENITH SERIES
12