Service manual
STANDARD MATTRESS RETAINER INSTALLATION
(USING 2 RETAINERS 999-0844-124)
1. Determine if you need to position your bed in an 80" or
76" conguration (80" outside holes; 76" inside holes - see
Details A and B).
2. On the foot end, carefully squeeze the Mattress Retainer
ends inward, toward the center of the retainer, and insert
the ends into the proper holes (see Details A and B).
3 Lay the Mattress Retainer down so that the elbows rest on
the decks and the long cross rod is on the foot end side as
shown.
4. On the head end, carefully squeeze the Mattress Retainer
ends inward, toward the center of the retainer, and insert
the ends into the proper holes (see Details A and B).
5. Lay the Mattress Retainer down so that the elbows rest on
the decks and the long cross rod is on the foot end side as
shown.
!
Be sure to use a mattress that is properly sized to t
the sleep deck, which will remain centered on the
deck relative to State and Federal Guidelines. Use of
an improperly tted mattress could result in injury or
death.
!
Use a properly sized mattress in order to minimize
the gap between the side of the mattress and assist
devices. This gap must be small enough to prevent
resident/patient from getting their head or neck
caught in this location.
ENSURE ALL THREE ADJUSTABLE PARTS
ARE PROPERLY POSITIONED FOR 76" OR 80"
CONFIGURATIONS (SEE PAGES 9 AND 11)
IMPORTANT
DETAIL A:
INSERT HEAD END
MATTRESS RETAINER
DETAIL B:
INSERT FOOT END
MATTRESS RETAINER
Outside holes for 80" Beds
Inside holes for 76" Beds
GF Health Products, Inc. - www.grahameld.com Zenith 7000 Service Manual 999-0843-190E
ZENITH SERIES
10