Certifications 2

Page 4 of 7
www.innofil3d.com | [e-mail]
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Engineering measures : Where reasonably practicable this should be achieved by the
use of local exhaust ventilation and good general extraction.
Provide appropriate exhaust ventilation at places where dust
is formed.
Control parameters : None.
Personal protective equipment
Eye protection : Safety glasses with side-shields. Goggles.
Skin and body protection : Impervious clothing.
Respiratory protection : Respirator must be worn if exposed to dust. Wear respirator
with dust filter. Respiratory protection is needed if any of the
exposure limits in Section 2 are exceeded. Consult an
industrial hygiene professional prior to respirator selection
and use. Use a positive-pressure air supplied respirator if
there is any potential for an uncontrolled release, exposure
levels are not known, or any other circumstances where air
purifying respirators may not provide adequate protection.
WARNING: Air purifying respirators do not protect workers in
oxygen deficient atmospheres.
Hand protection : Preventive skin protection.
Hygiene measures : Avoid contact with skin, eyes and clothing.
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance : Clear, translucent, opaque, pellets. Solid at room
temperature.
Color : Clear, Translucent, Opaque.
Odour : Sweet.
pH : Not applicable.
Vapor pressure : Not determined.
Vapor density : Not determined.
Evaporation rate : Not determined.
Density : 1.24 g/cc.
Boiling point/range : Not applicable.
Decomposition temperature : 250 °C (482F).
Melting point/range : 145 – 160 °C.
Water solubility : Insoluble.
Solubility in other solvents : None known.