Certifications 2

Page 3 of 7
www.innofil3d.com | [e-mail]
5. FIRE-FIGHTING MEASURES
Flammable properties : Autoignition temperature: 388 °C.
Suitable extinguishing media : Foam. Water. Carbon dioxide (CO
2
). Dry chemical. Alcohol
resistant foams are preferred if available. General-purpose
synthetic foams (including AFFF) or protein foams may
function, but much less effectively.
Hazardous decomposition : Burning produces obnoxious and toxic fumes Aldehydes
products Carbon monoxide (CO) carbon dioxide (CO
2
).
Special protective equipment : As in any fire, wear self-contained breathing apparatus
for firefighters pressure-demand, MSHA/NIOSH (approved or equivalent)
and full protective gear.
Under fire conditions : Cool containers / tanks with spray water. Water mist may be
used to cool closed containers.
Other information : Fine dust dispersed in air may ignite. Risks of ignition
followed by flame propagation or secondary explosions shall
be prevented by avoiding accumulation of dust, e.g. on floors
and ledges.
6. ACCIDENTAL RELEASE MEASURES
Personal precautions : Use personal protective equipment. See Section 8. Remove
all sources of ignition. Avoid dust formation. Avoid contact
with skin and eyes. Sweep up to prevent slipping hazard.
Environmental precautions : Do not flush into surface water or sanitary sewer system. Do
not allow material to contaminate ground water system.
Methods for cleaning up : Shovel into suitable container for disposal.
7. HANDLING AND STORAGE
Safe handling advice : Avoid contact with skin and eyes. Avoid dust formation.
Workers should be protected from the possibility of contact
with molten material during fabrication. Low hazard for usual
industrial or commercial handling. Use personal protective
equipment. See Section 8.
Storage conditions : Store in cool place. Keep at temperatures below 50 °C
(122F). No special restrictions on storage with other
products.
Precautions : No special precautions required.