Certifications 2

Page 2 of 7
www.innofil3d.com | [e-mail]
Specific hazards : No information available.
Flammability : Fine dust dispersed in air may ignite.
3. COMPOSITION / INFORMATION ON INGREDIENTS
Chemical nature
Chemical name : Polylactic resin
CAS Number : 9051-89-2
Weight : >98%
OSHA Exposure Limits : None
ACGIH Exposure Limits : None
All ingredients in quantities > 1% (0.1% for carcinogens) that are potentially hazardous per
OSHA definitions.
Other standards : This material can generate Particulates Not Otherwise
Classifiable (PNOC). The Occupational Safety and Health
Administration (OSHA) PEL/TWA for PNOC is 15 mg/m
3
for
total dust and 5 mg/m
3
for the respirable fraction. The
American Conference of Governmental Industrial Hygienists
(ACGIH) TLV/TWA for PNOC is 10 mg/m
3
for inhalable
particulates and 3 mg/m
3
for respirable particulates.
4. FIRST AID MEASURES
Inhalation : Move to fresh air. Call a physician immediately.
Skin contact : Rinse immediately with plenty of water for at least 15
minutes. If skin irritation persists, call a physician. Cool skin
rapidly with cold water after contact with hot polymer.
Eye contact : Rinse immediately with plenty of water, also under the
eyelids, for at least 15 minutes. Call a physician immediately.
Ingestion : Drink water as a precaution. Never give anything by mouth
to an unconscious person. Do not induce vomiting without
medical advice. Call a physician immediately.
Note to physician : Treat symptomatically.