User`s guide

BaseWall, Tel: [phone], Fax: [phone]
9
Some Status and Error conditions are indicated by combinations of
LED’s, as shown below
LED Action Condition
Status – System & Packets flash alternatively. Firmware Download in progress.
Status – System & Packets flash concurrently. MAC address not assigned.
Status – System (Solid Off) & Packets (Solid On)
SDRAM error
Status – System (Solid Off) & Packets (Flash once) Timer/Interrupt error
Status – System (Solid Off) & Packets (Flash twice) LAN/WAN error
Default Settings
When the Dual WAN VPN Firewall has finished booting, all configuration settings will be set to the
factory defaults, including:
• IP Address set to its default value of 192.168.1.1, with a Network Mask of
255.255.255.0
• DHCP Server is enabled
• User Name: admin
• Password cleared (no password)
TFTP Download
This setting should be used only if your Dual WAN VPN Firewall is unfit for use, and you wish to
restore it by uploading new firmware you should use the following procedure:
1. Power on the Dual WAN VPN Firewall.
2. Use the supplied Windows utility or a TFTP client program applies the new firmware. If you are
using the supplied Windows TFTP program, the screen will look like the following example.
Figure 1-4: Windows TFTP utility