User`s guide

BaseWall, Tel: [phone], Fax: [phone]
48
• Action
Connect – this button will initiate the tunnel
Submit Query – this button will add the policy
VPN Configuration – Tunnel to BaseWall Client
Tunnel to BaseWall Client – This describes an IPSec tunnel from a the VPN 3000 to the BaseWall
Client Software.
• VPN Tunnel List– here you can add a new tunnel or change an existing one from the list The
router can setup a maximum of 50 tunnels
• Tunnel Name– In order to distinguish the tunnels, you have to give the “Tunnel” a name..
• Tunnel – Only after you enable the tunnel check box, the tunnel can be connected.
• WAN port – You can choose WAN1, WAN2 or Any to make the VPN connection
• Local Security Network– These entries identify the private network on this VPN router, the
hosts of which can use the LAN-to-LAN connection. You can choose a single IP address, the subnet,
or a selected IP range to make VPN LAN-to-LAN connection.
• Distinguished name remote client – Use for example an email address
[e-mail]
• Preshared key - Choose a shared secret for this entry, this must be the same on both units.
• Action
Connect – this button will initiate the tunnel
Submit Query – this button will add the policy