User`s guide

BaseWall, Tel: [phone], Fax: [phone]
47
Tunnel to BaseWall Unit - This describes how to setup an IPSec tunnel to a BaseWall VPN
1000,2000,3000,4000,5000 and 6000.
VPN Configuration – Tunnel to Basewall Unit
• VPN Tunnel List– here you can add a new tunnel or change an existing one from the list The
router can setup a maximum of 50 tunnels.
• Tunnel Name– In order to distinguish the tunnels, you have to give the “Tunnel” a name..
• Tunnel – Only after you enable the tunnel check box, the tunnel can be connected.
• WAN port – You can choose WAN1, WAN2 or Any to make the VPN connection.
• Local Security Network– These entries identify the private network on this VPN router, the
hosts of which can use the LAN-to-LAN connection. You can choose a single IP address, the subnet,
or a selected IP range to make VPN LAN-to-LAN connection.
• Remote Security Network– These entries identify the private network on the remote peer VPN
router whose hosts can use the LAN-to-LAN connection. You can choose a single IP address, the subnet,
or a selected IP range to make VPN connection
• Remote Security Gateway – You can select the remote side IP address (WAN IP address) as your
remote side security gateway
• Preshared Key – Choose a shared secret for this entry, this must be the same on both units.