User`s guide

BaseWall, Tel: [phone], Fax: [phone]
30
Advanced configuration – virtual server
Virtual Server Configuration
• Enable – The enable checkbox is to Enable or Disable each Virtual server as required.
• Server Name – Enter a suitable name for this server. (By default, there are 12 well-known
virtual servers have been list on the Custom Virtual Server List)
• Protocol – Select the network protocol (TCP/UDP) used by this sever.
• IP Address – LAN, Enter the IP address of the server on your LAN which is running the
required Server software.
Each Host (server) should have a fixed IP address, or have a reserved IP address. (See the
Host IP section earlier in this Chapter for details on reserving an IP address.)
Each Host (server) must be running the appropriate Server software
• WAN – This selection allows this server to bind on any WAN ports, or even bind all WAN
ports together.
• LAN Port Range – Enter the range of port number used for outgoing traffic from this
Server. If only a single port is required, enter it in both fields.
• WAN Port Range -– Enter the range of port number used for incoming traffic to this Server.
If only a single port is required, enter it in both fields
• Allowed Remote IP – It allows only a range of remote side IP address to access the virtual
servers. The default is 0.0.0.0 ~ 0.0.0.0, means all remote side IP address can access it.
Buttons
• Add – Create a new Virtual Server entry.