User`s guide

BaseWall, Tel: [phone], Fax: [phone]
26
Advanced configuration – Routing
Routing
This section is only relevant if your LAN has other Routers or Gateways.
• If you don't have other Routers or Gateways on your LAN, you can ignore the Static
Routing page completely.
• If your LAN has other Gateways and Routers, you must configure the Static Routing
screen as described below. You also need to configure the other Routers.
Note:
If there is an entry or entries in the Routing table with an Index of zero (0), these are System
entries. You cannot modify or delete these entries.
Dynamic routing
• RIP v2 – This acts as a “master” switch. If enabled, the selected WAN or LAN will
run RIPv1/v2, otherwise they don’t have RIP function.
• Interface – LAN, WAN1 – n, is enabled, any WAN or LAN can execute RIP
function.
Static routing
• Network Address – The network address of the remote LAN segment. For
standard class "C" LANs, the network address is the first 3 fields of the Destination
IP Address. The 4th (last) field can be left at 0.