User manual

- BaseWall VPN 6000 user manual -
1 Installation
1.1 Requirements
To insure a smooth installation of your BaseWall VPN 6000, we should make
sure to have all the necessary equipment and information ready. To configure
your firewall for the first time we will need:
1x BaseWall VPN 6000
1x Standard power cord (bundled with BaseWall VPN 6000)
2x UTP RJ45 cables (one is bundled with BaseWall VPN 6000)
1x UTP RJ45 cross cable or UTP hub/switch for initial configuration
1x PC or notebook computer
If we are to set up your firewall to handle one or more Internet connections, we
will also need:
Connection details provided by your Internet Service Provider (ISP)
1.2 Getting to know your BaseWall VPN 6000
1.2.1 Front
1.2.2 Back
1.3 Hardware installation
➔ Use the power cord to connect the BaseWall VPN 6000's power socket (15) to
a standard wall power outlet.
➔ Switch the firewall on, using the power switch (16), on the back of the
device.
Booting the hardware for the first time may take up to 1 minute.
When the firewall is switched on and ready, you should hear 3 short beeps. If
you have not heard 3 beeps within 1 minute of switching on the device, please
refer to section 1.13 ( Errors and recovery).
Page 6 / 79
1. LCD display
2. Serial port
3. WAN1 port
4. WAN1 connection LED
5. WAN2 port
6. WAN2 connection LED
7. FLEX1 port
8. FLEX1 connection LED
9. FLEX2 port
10. FLEX2 connection LED
11. FLEX3 port
12. FLEX3 connection LED
13. FLEX4 port
14. FLEX4 connection LED
15. Power socket
16. Power switch