User manual

- BaseWall VPN 6000 user manual -
➔ Choose the type of VPN IPSec tunnel you wish to configure. In this example
we will connect to a “Remote network”.
➔ Choose the “authentication method” we will use for the VPN IPSec tunnel.
(May be either “Pre-shared key (PSK)” or “Certificate” if you have a valid
certificate.) In our example we will use a Pre-shared key.
➔ Click the “Next” button.
The “Create IPSec-tunnel” screen will change.
➔ Choose the Internet connection that will be used for this VPN IPSec tunnel
(usually your “default” connection).
➔ Enter the Internet IP address of the router or firewall on the other end of the
tunnel.
➔ Enter the LAN IP address of the router or firewall on the remote network you
wish to connect to.
➔ Enter the net mask of the remote network you wish to connect to.
(Depending on the method of authentication you chose)
➔ Enter a pre-shared key (if you chose to authenticate by means of a pre-
shared key like we have in this example).
OR
➔ Enter your certificate's asn1dn subject (if you have chosen to authenticate
with a security certificate).
➔ Click the “Next” button.
You should be taken back to the “List IPSec-tunnels” view.
Page 46 / 79