User manual

- BaseWall VPN 6000 user manual -
➔ Power down the firewall (using the power switch on the back of the device).
➔ Power down your notebook or laptop.
➔ Detach the network cables from the PC or notebook and the firewall.
➔ Using one of the bundled RJ45 UTP cables, connect the WAN1 interface to the
router or modem used for your primary (default) Internet connection.
➔ If you make use of a secondary (fall back) Internet connection, connect the
WAN2 interface to the modem or router used for your secondary (fall back)
Internet connection.
➔ Using one of the bundled RJ45 UTP cables, connect the FLEX1 interface on
the firewall to the switch, router or hub you will use for your local network.
➔ Power up the firewall (using the power switch on the back of the device).
➔ Check for three beeps to indicate the device has booted up correctly. If you
do not hear the three beeps, please refer to section 1.13 ( Errors and
recovery).
➔ Check that WAN1, WAN2 (if in use) and FLEX1 connection LED's (above the
corresponding network ports) light up. If one does not, please refer to section
1.13 ( Errors and recovery).
Page 29 / 79