User manual

- BaseWall VPN 6000 user manual -
The configuration window has a different layout. The left bar now contains a list
of wizards and there are now different tabs “CONFIG”, “NETVIEW”, “MAIL” and
“PROXY”. The current windows shows the factory configuration of the firewall.
With the current network 192.168.99.0 where the firewall occupies the
192.168.99.99 ip address. There are 2 Internet connections defined but with
initial values. After the “First install” wizard the picture should show the correct
addresses for your situation.
1.6 Running the “First install” wizard
The “First install” wizard was intended to allow you to quickly and efficiently
tailor the BaseWall VPN 6000 to match your network's needs and settings.
Whenever you start a “First install” wizard, all current configuration data will be
lost.
At a first installation this should not pose a problem. However, if you ever feel
you should change important configuration data at a later stage, you are
encouraged to use the “Local Area Networks” or “Internet Connections”
wizards from the “Configuration” context instead.
You may start the “First install” wizard by pressing the red “First install” text, in
the left hand side of the screen, between “Current Status” and “Configuration”.
➔ Start the “First install wizard”
When you start the “First install” wizard, a warning screen signals the start of
this wizard. The screen is there to prevent you from inadvertently starting the
“First install” wizard at a later time, thereby deleting all your current network
Page 17 / 79